Jackets That ROCK!     

#1   vision becomes plan...

 

Every good design starts with a plan.  The biggest challenge in fitting is proportion and comfort.  Starting with the shoulders, we shape each dress form for round, square, wide & narrow.    Shape shoulders on the dress form!               

#2  shoulders...the anchor of your jacket.

                  #1 Match the shoulder slant and shoulder width...the shoulders will be the anchor for your fabric.                   

  #2 In order for the shoulder to feel comfortable, (without sliding forward or slipping back), the back shoulder piece is longer than  the front.  The back shoulder should also be wider than the front shoulder piece. Add 3/8 inch ease at the back shoulder, for extreme comfort and movement...tiny gathers that become invisible when pressed. Like this...

(If your pattern does not have a wider and longer back shoulder piece,  slice your pattern and spread it 3/8".) 

If your pattern does not have a wider and longer back shoulder piece,  slice your pattern and spread it 3/8". 

#3 upper chest and bust...for movement.

Check your movement areas.  You can give your pattern a little push by adding a tiny curve at the underarm.  (see pattern piece below).  And...Gotta do this fitting with the right shoulder pad in place.          

  #1 match your shoulder on the dress form, #2 fit the body with the shoulder pad placed.

#4

armhole position...

The armhole on a classic jacket is lower and wider than a skinny jacket.   The opening is shaped like an egg tipped slightly forward.  The armhole follows the shape of the arm.     Here's what it looks like...

If you find the sleeves are pulling...#1 raise the armhole position, (picture #2)  Ease the back sleeve seam above and below the exact vertical elbow position.  (#3) below

Whatever you add (or subtract) to the arm hole...add (or subtract) the same amount to the sleeve.          

Check the elbow and shoulder position by bending the flexible arms on your dress form; matching your elbow position. Just a sneak preview of shoulders and sleeves...do not miss how easy this is.  Coming next.  Almost all sleeve problems are blamed on the back upper arms of the sleeve.  Here's the deal.  Once the bodice is balanced, and the sleeve is contoured at the upper arm and elbow for movement...you can re-create the same pattern, with variations into infinity...each one set for dancing all night!  

#5

waist and hip position...

Vertical darts on the bodice at the waist will give you lots of room to play and make changes in the silhouette.  Be sure to match all of your own vertical positions on your dress form: bust, waist and hipline.

#6

grainlines & pressure points.

The blue dots on the pattern represent areas of movement: at the shoulder. the underarm, across the back. bust. and elbow.  Notice how the back pattern center seam is slightly contoured for extreme movement in this jacket.  Every movement area has a seam that can be easily adjusted for silhouette.

The back sleeve is slightly eased above and below the elbow point.

®

as always, keep the grainline straight...

1. Match the vertical bust, waist and hip points on your jacket

2. Give all pressure points (movements areas), ease or extra fabric 

possibilities are endless...


Whatever the project...whatever the fit...Start by matching your body frame and shape on the dress form.  

same pattern...slight changes...

 

  • Match the body frame and build it out
    ( The fit gives you freedom to move when you match the pressure points (curves) on your dress form with the pads in the Fitting System.)

NO STRESS!  JUST SHAPE YOUR DRESS FORM AND CREATE!

Fabulous Fit®

Jill Ralstom

All Rights Reserved © (thank you!)